Bogen CAM2 Specifiche Pagina 1

CAM2 Mixer/Pre-AmplifierInstallation and Use Manual© 2003 Bogen Communications, Inc.All rights reserved. Specifications subject to change.54-2039-01C

Input ConnectionsMicrophone InputsMicrophones are connected to the CAM2 using the MIC1 through MIC 4 connectors. The CAM2 uses male XLRtype connectors

Panel DescriptionsFront Panel1. Input Over Voltage LEDs (Clipping LED) - LED will light when input is overdriven.2. MIC Channel Gain Controls - Contro

OperationPowerThis switch applies power to the unit.The Switch Actuator will light to indicate power "ON" whenconnected to an AC power sourc

Audio System LevelSetting System LevelsIn audio systems that employ separate mixers and amplifiers, there are quite a few controls that affect the vol

SpecificationsRated Output LevelsBal Out +4 dBu or -50 dBu (switch selected)Line Out 0 dBuFrequency Response +/- 1dB 20 Hz to 20 kHz Distortion at Rat

NoticeEvery effort was made to ensure that the information in thisguide was complete and accurate at the time of printing.However, information is subj

CAM2 Mixer/Pre-AmplifierInstallation and Use Manual© 2003 Bogen Communications, Inc.All rights reserved. Specifications subject to change.54-2039-01C

NoticeEvery effort was made to ensure that the information in thisguide was complete and accurate at the time of printing.However, information is subj

SpecificationsRated Output LevelsBal Out +4 dBu or -50 dBu (switch selected)Line Out 0 dBuFrequency Response +/- 1dB 20 Hz to 20 kHz Distortion at Rat

Audio System LevelSetting System LevelsIn audio systems that employ separate mixers and amplifiers, there are quite a few controls that affect the vol

OperationPowerThis switch applies power to the unit.The Switch Actuator will light to indicate power "ON" whenconnected to an AC power sourc

Panel DescriptionsFront Panel1. Input Over Voltage LEDs (Clipping LED) - LED will light when input is overdriven.2. MIC Channel Gain Controls - Contro

Input ConnectionsMicrophone InputsMicrophones are connected to the CAM2 using the MIC1 through MIC 4 connectors. The CAM2 uses male XLRtype connectors

Output ConnectionsBAL/OUT to Balanced Input of Other EquipmentThe CAM2 provides a balanced output signal from the male XLR connector labeledBAL/OUT. M

Output ConnectionsBAL/OUT to Balanced Input of Other EquipmentThe CAM2 provides a balanced output signal from the male XLR connector labeledBAL/OUT. M