Bogen C35 Manuale Utente

Classic Series AmplifiersC35, C60, & C100 ModelsInstallation and Use Manual© 2003 Bogen Communications, Inc.All rights reserved.Specifications sub

Power Output (RMS)C35: 35WC60: 60WC100: 100WFrequency Response& DistortionTransformer†: 70 - 16 kHz (± 2 dB) @ 1% max.4-Ohm Direct Output: 20 - 20

Troubleshooting9PROBLEM CONDITION CAUSENO SOUNDPower Switch Indicator is OFF.• Amplifier not plugged in.• AC outlet dead.• Power switch off.• Circuit

Bogen Classic Series Amplifiers are warranted to be free from defects in material or workmanship for two (2) years from the dateof sale to the origina

NoticeEvery effort was made to ensure that the information in thisguide was complete and accurate at the time of printing.However, information is subj

ContentsPagePANEL DESCRIPTIONS...2-3Classic Series Fron

Panel DescriptionsClassic Series Front Panel1. MIC1 Level ControlIndividual level control for a dedicated microphone input.2. MIC2/AUX1 Mode SwitchSwi

Panel DescriptionsClassic Series Rear Panel1.Amplifier OutputScrew terminal strip containing all available speaker outputs.2.Tape/BoosterRCA unbalance

InstallationPackage Contents• Classic Series Amplifier• Instruction ManualVentilationWhen using a shelf or table mount, the amplifier should stand alo

ConnectionsInput ConnectionsMicrophone ConnectionsThese inputs are for two low-impedance balanced dynamic microphones.Connect cable shield to center s

OperationFront Panel ControlsPowerThe front panel ON/OFF switch applies power to the amplifier and is illumi-nated when power is ON.Input Volume Cont

7OperationRear Panel ControlsTEL Volume ControlThe TEL VOLUME control on the rear panel adjusts the TEL input’s paginglevel. It does not affect the m